IC697ACC722

Blank Slot Interrupt Jumper (IC697ACC722)

The IC697ACC722 Blank Slot Interrupt Jumper is an accessory designed for the IC697 PLC systems. Its primary function is to reserve a slot for future expansion while maintaining the continuation of interrupt signals through the backplane in a rack configuration. This ensures proper communication and interrupt handling, even if the slot is temporarily unused.

    Slot Reservation: Allows a slot to be reserved for future expansion purposes.
    Continuation of Interrupt Signals: Ensures the interrupt signal can continue through an empty slot in the IC697 PLC rack's backplane.
    Simple Connector: A single connector mounted on the board, which easily connects to the backplane.
    Easy Installation: Provides simple connectivity with the backplane’s mating connector.

Functionality

The Blank Slot Interrupt Jumper enables proper operation of modules located to the right of the blank slot in the PLC rack. These modules may require continuation of the interrupt signal to function correctly. This accessory is particularly useful when future expansion is planned but certain slots are not yet populated.

Installation

    Power Off Requirement: Ensure the power to the rack is turned off before attempting to install the Blank Slot Interrupt Jumper.
    Slot Placement: The jumper can be installed in slots 2 through 8 of a nine-slot rack or slots 2 through 4 of a five-slot rack. It should not be installed in slot 1 or in the last slot (slot 9 for nine-slot racks or slot 5 for five-slot racks), as it is unnecessary for these positions.
    Configuration with Software: The jumper must be added to the system configuration using the IC641 Programming Software to ensure proper function. If an earlier version (2.05 or before) of the programming software is used, configure the jumper as a Bus Transmitter Module (IC697BEM713). However, in future versions of the software, there will be an option specifically for the Blank Slot Interrupt Jumper, eliminating configuration mismatches.

Configuration Considerations

In earlier versions of the IC641 Programming Software (before version 2.05), the Blank Slot Interrupt Jumper can be configured as a Bus Transmitter Module (BTM) or any other placeholder module. After configuration, the system may display a warning about a configuration mismatch, which can be ignored. Future software updates will have a dedicated option for configuring this jumper, preventing any mismatches.

References

    Programmable Controller Installation Manual
    Programming Software User's Manual
    Programmable Controller Reference Manual

Ordering Information

    Blank Slot Interrupt Jumper Assembly (Pack of 6): Catalog Number IC697ACC722

This accessory is essential for maintaining interrupt signal integrity in IC697 PLC racks, especially when planning for future system expansions.

>> GE Fanuc IC697ACC722 User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc

Reminder: GE Fanuc IC697ACC722 and other Ge-Fanuc modules are available for sale at Otomasyon Mall. Please note that some of the devices are used products, so take this into consideration when purchasing. However, once products are out of stock, new ones will not be restocked. The information above is based on general knowledge and does not guarantee accuracy. For more detailed and precise information, it is recommended to refer to the relevant device’s user manual. 06.03.2013 

"Please note: The user manuals, commissioning suggestions, error codes, and solution recommendations provided on this page are not binding. The information and documents above are open to and even in need of improvement. As the Otomasyon Mall Community, we gladly welcome your suggestions and contributions. If you have field experience and insights on ease of use, please do not hesitate to share them with us."