IC693CBL332

IC693CBK003 Cable Kit includes both the IC693CBL331 (left side) and IC693CBL332 (right side) cables. These cables are designed to connect I/O modules to terminal blocks in Series 90-30 PLC systems.


IC693CBL332:

This cable is a 24-pin, 90-degree angled cable that connects to the right side of an I/O module. It is 2.0 meters in length and replaces the older IC693CBL322 cable. This cable is used with 16-point I/O modules that feature a TBQC (Terminal Block Quick Connect) I/O faceplate adaptor.


I/O Face Plate for 16-Point Modules:

The I/O Face Plate (catalog number IC693ACC334) includes a 24-pin connector that links to the applicable terminal block through cables of 0.5, 1, or 2 meters in length. This face plate is used as a replacement for the standard terminal board on 16-point modules, enabling connection to TBQC assemblies.


I/O Face Plate Installation:

    Install the terminal block assembly on the DIN rail:
    Snap the terminal block into place at the desired location on the DIN rail.

    Remove the 20-pin terminal assembly from the module:
    Open the plastic terminal board cover, push up on the jacking lever to release the terminal block, and pull the tab until the contacts separate and the terminal block is fully removed.

    Snap the I/O Face Plate assembly onto the module:
    Install the I/O Face Plate onto the module where the standard terminal board was removed.

    Connect the cable:
    Connect the selected cable (0.5, 1, or 2 meters) from the I/O Face Plate to the terminal block connector.

For wiring information, refer to the Series 90-30 PLC I/O Module Specifications Manual (GFK-0898).


Cable Function:

These cables are used with 16-point I/O modules that are equipped with a TBQC I/O faceplate adaptor. Both ends of the cable have straight 24-pin female connectors, and the cable provides a direct connection between the module and the terminal block. The wiring is pin-to-pin, meaning each pin on the module connects directly to the corresponding pin on the terminal block (e.g., Pin A1 to Pin A1, Pin A2 to Pin A2, etc.).

The I/O faceplate assembly (catalog number IC693ACC334) is necessary for using these cables, as it replaces the module’s standard 20-pin terminal block assembly. There are five different terminal blocks available to support a variety of I/O modules. For more details on the TBQC assemblies, refer to Appendix J.



+  IC693CBL332 User manual (pdf)

>> Ge fanuc 90-30 User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc

Reminder: IC693CBL332 and other Ge-Fanuc modules are available for sale at Otomasyon Mall. Please note that some of the devices are used products, so take this into consideration when purchasing. However, once products are out of stock, new ones will not be restocked. The information above is based on general knowledge and does not guarantee accuracy. For more detailed and precise information, it is recommended to refer to the relevant device’s user manual. 06.03.2013 

"Please note: The user manuals, commissioning suggestions, error codes, and solution recommendations provided on this page are not binding. The information and documents above are open to and even in need of improvement. As the Otomasyon Mall Community, we gladly welcome your suggestions and contributions. If you have field experience and insights on ease of use, please do not hesitate to share them with us."