IC693CBL327
IC693CBL327 Overview and Connection Details
Left Side: Features a 24-pin, 90-degree angled connector.
Right Side: The cable length is 3.0 meters (about 10 feet).
Blue Band: The blue band on the label indicates compatibility with the MDL654 low-voltage module.
Connectors and Cables:
Connections are made to the module through two male 24-pin connectors (Fujitsu FCN–365P024–AU) located on the front of the module. The wiring to field devices uses a cable with a female connector on one end and stripped and tinned wires on the other end.
You can purchase pre-wired cables with catalog numbers IC693CBL327 and IC693CBL328, or you can make your own cables. More information can be found in Appendix B.
Installation Guidelines:
TTL Wiring Practices: Follow standard TTL wiring principles when installing this module.
Noise Immunity: The I/O control lines connected to this module should be no longer than 30 meters, as signal attenuation limits the wiring length.
Pin Layout and Wiring Diagram:
The pin layout is detailed with connections like:
I25, I27, I29, I31, COM, NC, 5V OUT, NC, and so on.
Positive and negative connections are clearly marked as -- + and + --.
If the 24V OUT pin is used to connect to field devices, the isolation specification changes to:
Field to Backplane (optical) and frame ground: 50 VAC continuous, 500 VAC for 1 minute.
TTL Wiring for Negative Logic:
To work with TTL outputs, it’s recommended to use the negative logic configuration as shown in the wiring diagram.
That’s a breakdown of the main features for the IC693CBL327 cable! Let me know if you need any more info or clarification!
>> IC693CBL327 cables User manual (pdf)
----------
+ Ge-Fanuc Contact (for Automation Mall)