IC693CBL317
The IC693CBL317 is a special 10 feet (3 meters) long APM I/O cable that connects one of the 24-pin connectors on an APM module to the terminal block. This cable is similar to the IC693CBL311, but its drain shield wire is brought outside of the connector through an 8-inch external shield pigtail, which improves the module’s noise immunity. Each APM module requires two cables for operation.
APM Modules Supported:
IC693APU301
IC693APU302
Function of the Cable:
This I/O Interface Cable consists of a 24-pin I/O connector, the cable itself, and a 25-pin D-type terminal block connector. It is used to connect Power Mate APM Modules (IC693APU301 and IC693APU302) to drives and machines. These APM modules have two male 24-pin connectors on the front, and two of these cables are required to connect the module to the drive and machine.
IC693CBL311 is a 10 feet (3 meters) long cable.
IC693CBL319 is a 3 feet (1 meter) long cable.
IC693CBL317 (the one described here) is similar to the above but includes the 8-inch external shield pigtail for improved noise immunity.
Improved Noise Immunity:
The IC693CBL317 and IC693CBL320 cables have their drain shield wire disconnected from pin B12 and routed externally via an 8-inch pigtail, enhancing the Power Mate APM’s ability to resist electrical noise. This makes these cables better suited for environments where electromagnetic interference (EMI) is a concern.
Wiring and Installation:
Each connector on the module is typically connected by a short I/O Interface cable to a terminal block. The cable that connects the I/O connector to an external terminal block can be shortened to meet installation requirements. For more details on wiring, refer to:
Manual GFK-0840 (standard mode)
Manual GFK-0781 (follower mode)
These manuals provide further information about APM terminal blocks and the required wiring configurations.
+ IC693CBL317 User manual (pdf)
>> Ge fanuc 90-30 User manual (pdf)
----------
+ Ge-Fanuc Contact (for Automation Mall)