IC693MDL654

The IC693MDL654 5/12 Volt DC (TTL) Positive/Negative Logic Input Module

This module provides 32 discrete TTL input points that operate at 5/12 volts DC. The inputs are arranged into four isolated groups (A1 - A8, B1 - B8, C1 - C8, D1 - D8), and each group has its own common terminal. The inputs support both positive and negative logic and can handle voltage levels up to 15V. For compatibility with TTL outputs, it’s recommended to use the negative logic configuration.
Details:

    Positive logic: The input device sources current from the positive power supply to the module.
    Negative logic: The input device sinks current from the module to the negative power supply.

When current flows into an input, it registers as a logic 1 in the input status table.
Power Supply:

The module provides a regulated +5V supply (limited to approximately 150 mA) via the I/O connectors. This internal supply is isolated from the backplane. If you choose, you can use jumpers to power the inputs from this internal supply instead of using an external supply. However, this will place additional load on the PLC’s +5V power supply. Opto-couplers are used to isolate the field side from the logic side.

LED indicators labeled A1 - A8, B1 - B8, C1 - C8, D1 - D8 show the ON/OFF status of each input.
Connections:

Connections to the input devices are made via two 24-pin connectors located on the front of the module. The connector on the right handles Groups A and B, while the left connector handles Groups C and D. You can use pre-wired cables or make your own using the specifications provided by GE Fanuc.
Key Specs:

    Rated Voltage: 5 to 12V DC, Positive or Negative Logic
    Input Voltage Range: 0 to 15V DC
    Inputs per Module: 32 (four groups of eight inputs each)
    Isolation: 1500V between field and logic sides, 250V between groups
    Input Current: 3.0 mA at 5V DC, 8.5 mA at 12V DC (typical)
    On-State Voltage: 4.2 to 15V DC
    Off-State Voltage: 0 to 2.6V DC
    On-State Current: 2.5 mA minimum
    Off-State Current: 1.2 mA maximum
    On/Off Response Time: 1 ms (maximum)

Power Consumption:

    195 mA maximum from the +5V bus on the backplane.
    If the module’s internal +5V supply is used to power the inputs, consumption may go up to 440 mA with all 32 inputs ON.
    96 mA typical from the user’s input supply at 5V DC and 272 mA at 12V DC with all 32 inputs ON.

This module is ideal for systems using TTL input devices. It supports both positive and negative logic, making it versatile for various applications. Its fast 1 ms response time ensures quick and efficient operation in automation setups.

>> IC693MDL654 User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc

Reminder: IC693MDL654 and other Ge-Fanuc modules are available for sale at Otomasyon AVM. Please note that some of the devices are used products, so take this into consideration when purchasing. However, once products are out of stock, new ones will not be restocked. The information above is based on general knowledge and does not guarantee accuracy. For more detailed and precise information, it is recommended to refer to the relevant device’s user manual. 06.03.2013