IC693MDL653

The IC693MDL653 24 Volt DC Positive/Negative Logic Input Module


This module provides 32 input points split into four isolated groups of 8 points each. Each group has two common pins that are internally connected. The module supports both positive and negative logic, which means you can wire it to sink or source current, depending on your application.

    Positive logic: The module sinks current from the input device to the negative power bus (common). The input device is connected between the positive power bus and the circuit input.
    Negative logic: The module sources current through the input device to the positive power bus. The input device is connected between the negative power bus and the circuit input.

When current flows into an input point, it registers as a logic 1 in the input status table (%I).

This module is compatible with many types of input devices like pushbuttons, limit switches, and proximity switches. However, power to operate the field devices must be provided by the user.
Connections:

Connections are made through a 50-pin connector on the front of the module. You can get prewired cables from GE Fanuc that simplify installation. Important note: This module does not have LED indicators for showing circuit status.
Key Specs:

    Rated Voltage: 24V DC
    Input Voltage Range: 24V DC (+10%, –20%)
    Inputs per Module: 32 (four groups with two commons per group)
    Isolation: 1500V between the field side and logic side
    Input Current: 7.5 mA (average) at rated voltage
    On-State Voltage: 15V DC minimum
    Off-State Voltage: 6V DC maximum
    On-State Current: 4.5 mA minimum
    Off-State Current: 2 mA maximum
    On/Off Response Time: 2 ms max (for both ON and OFF)

Power Consumption:

    5 mA (when 16 inputs are on) from the 5V bus on the backplane.

Installation:

The IC693MDL653 can be installed in any I/O slot of a 5 or 10-slot baseplate in a Series 90-30 PLC system. You’ll need to connect your input devices to the 50-pin connector on the module’s front.

This module is ideal for fast input devices, with an ON and OFF response time of just 2 milliseconds. However, you can only turn on a maximum of 16 inputs at the same time.

In short, the IC693MDL653 is a versatile input module designed for applications requiring both positive and negative logic, and it’s great for connecting a wide range of input devices in industrial automation setups.

>> IC693MDL653 User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc

Reminder: IC693MDL653 and other Ge-Fanuc modules are available for sale at Otomasyon AVM. Please note that some of the devices are used products, so take this into consideration when purchasing. However, once products are out of stock, new ones will not be restocked. The information above is based on general knowledge and does not guarantee accuracy. For more detailed and precise information, it is recommended to refer to the relevant device’s user manual. 06.03.2013