IC693MDL632

GE FANUC IC693MDL632

The 125 Volt DC Positive/Negative Logic Input module comes with 8 input points. It’s divided into two groups, with 4 inputs in each group. These groups are not connected inside the module; each group works with a separate common.

How Does It Work?

    Positive logic: It sinks the current from the input device to the user common or the negative power bus.
    Negative logic: It sources current through the input device to the user common or positive power bus. The device is placed between the power bus and the module input. When current flows into an input point, it registers as a 1 (logic 1) in the input status table (%I).

What Devices Can You Use With It?

    Push buttons
    Limit switches
    Electronic proximity switches

You’ll need to provide power for the field devices yourself. So, yes, you’ll have to bring your own power supply.

What Does the LED Indicator Do?

At the top of the module, there are LEDs that show whether each input is ON or OFF. There are eight green LEDs, labeled A1 through A8. Additionally, there’s circuit wiring information inside the hinged door, and you can write circuit identification info on the outside. The outer left edge of the insert is colored red to indicate it’s a high-voltage module.

Installation:

You can install this module into any I/O slot on a 5 or 10-slot baseplate, so it’s quite flexible in terms of placement.

Key Technical Details:

    Rated Voltage: 125V DC (Positive or Negative Logic)
    Input Voltage Range: 0-150V DC
    Number of Inputs: 8 (2 groups of 4 inputs each)
    Isolation: 1500V between the field and logic sides, 500V between groups
    Input Current: 4.5 mA typical
    On-State Voltage: 90-150V DC (On)
    Off-State Voltage: 0-30V DC (Off)
    On/Off Response Time: 7 ms
    Internal Power Consumption: 40 mA (from the 5V bus) and 36 mA (from user input supply with all inputs ON)

One Last Thing:

If you’re wondering how the module performs when the temperature rises, the number of inputs that can be on at the same time decreases with higher temperatures. For example, at 45°C, only 2 inputs can remain on.

Wiring and Connections:

When setting up the wiring, make sure to correctly route the currents entering the module. Also, remember that negative logic connections are shown with dashed lines in the wiring diagrams.

>> IC693MDL632 User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc

Reminder: IC693MDL632 and other Ge-Fanuc modules are available for sale at Otomasyon AVM. Please note that some of the devices are used products, so take this into consideration when purchasing. However, once products are out of stock, new ones will not be restocked. The information above is based on general knowledge and does not guarantee accuracy. For more detailed and precise information, it is recommended to refer to the relevant device’s user manual. 06.03.2013