6ES7332-8TF00-0AB0

Siemens 6ES7332-8TF00-0AB0 – SM 332 HART Analog Output Module

6ES7332-8TF00-0AB0 is a Siemens SM 332 HART module with 8 analog current outputs. It supports 0–20 mA and 4–20 mA output ranges and operates in an ET 200M station with a suitable IM 153-2 interface module. Although listed among S7-300 analog modules, selection must account for the station architecture and interface compatibility, as well as the physical format.

Output signals and HART functionality

This module sends analog current commands to compatible field actuators, such as valve positioners. It has no 0–10 V or ±10 V voltage outputs. Applications requiring voltage signals need a different module or an appropriate analog signal converter.

Each channel can be configured with HART enabled, HART disabled, or the channel deactivated. HART communication provides digital data exchange with a compatible field device alongside the analog current command. A working current output does not, by itself, confirm working HART communication. Check both the field device's HART support and the communication path through the system.

Key technical specifications

Outputs: 8 AO. Output ranges: 0–20 mA / 4–20 mA. Rated load supply: 24 V DC. Resolution: maximum 16 bits including sign, as specified in the data sheet. Maximum load impedance: 750 Ω within the rated output range. Front connector: 20-pin.

Assess the actuator input resistance together with the effects of cabling and any intermediate devices. Check the capacity and loaded voltage of the 24 V panel power supply. The module supports diagnostic alarms and readable diagnostic information, with electrical isolation between the analog outputs and the backplane bus. This does not establish individual channel-to-channel isolation.

Distinguishing 8TF00 from 8TF01

6ES7332-8TF00-0AB0 and 6ES7332-8TF01-0AB0 are different order numbers. When replacing a module, check the hardware entry in the Siemens S7 project, the IM 153-2 version and output behavior during CPU STOP/RUN transitions. Siemens' manual for the later version documents configuration-dependent differences in this behavior. Advanced features listed for 8TF01 must not automatically be assumed for 8TF00.

Used-module selection and channel testing

For a used unit, check the complete label code, hardware revision and connector condition. Test every output at 4, 12 and 20 mA with a suitable load; if HART is required, test communication separately with a compatible device. A command value displayed in the PLC program or on an HMI panel does not prove that the physical output current is correct.

PDF files and technical documentation

For wiring diagrams and manuals, use the S7-300 files section. Match the documentation to 6ES7332-8TF00-0AB0; do not apply sections covering only the 8TF01 revision directly to the older module.

Related topics and product categories

S7-300 main page  |  S7-300 CPU modules  |  Digital input modules

Digital output modules  |  Special and function modules  |  Analog module range

Used Siemens products  |  Second-hand main page  |  OtomasyonAVM home

Manufacturer references

Siemens – HART analog output modules and revision notes  |  Siemens – S7-300 front connector selection