6ES7322-1FH00-0AA0

Siemens 6ES7322-1FH00-0AA0 – SM322 16-Output 120/230 V AC Module

6ES7322-1FH00-0AA0 is a Siemens SIMATIC S7-300 SM322 digital output module with 16 electronic AC outputs. Its rated load voltage is 120/230 V AC, with a nominal output current of 1 A per channel. When selecting S7-300 digital output modules, consider load voltage, channel and group currents, cabinet temperature, mounting orientation and connector compatibility.

Electronic AC outputs and system role

The module switches suitable AC loads under commands from the S7-300 CPU. Outputs form two isolated groups of eight channels. For AC contactor coils, valves and indicator lamps, check starting current as well as continuous consumption.

Match output addresses in the PLC program to the installed hardware. Evaluate the power supplies for the CPU and auxiliary circuits separately from the AC load circuits switched by this module.

Channel current and group limits

The maximum channel current is 1 A from 0 to 40 °C and 0.5 A above 40 °C up to 60 °C. The total per group is limited to 4 A with horizontal mounting up to 40 °C, 2 A up to 60 °C, and 2 A with vertical mounting up to 40 °C.

Do not assume all eight outputs can supply 1 A simultaneously. For example, eight 0.5 A loads total 4 A, exceeding the limit wherever the 2 A group rating applies. Paralleling outputs to increase current capacity is not supported.

Small loads and off-state behaviour

The minimum load current is 10 mA, while maximum off-state residual current is 2 mA. Check these values when selecting low-consumption lamps or electronic inputs. A voltage measured with a high-impedance instrument at an inactive output is insufficient by itself to diagnose a fault; use a suitable load and measurement method.

20-pin connection, fuses and indicators

The module requires one 20-pin front connector. Each output group has an 8 A / 250 V fuse, with fast-acting replacement fuses specified. An 8 A fuse does not make the group's permitted operating current 8 A. Check terminal tightness, conductor sizing and circuit protection against the cabinet design.

Green LEDs indicate channel status; the red SF indicator can indicate fuse or L1/N supply problems. Diagnostic interrupts are not supported. Consider suitable feedback through digital inputs to compare commands with actual machine operation. A command displayed on an HMI is not confirmation of equipment status.

Assessing a used module

When assessing this model among used Siemens products, check all 16 outputs and both supply groups with suitable AC loads. Investigate outputs remaining on, excessive voltage drop under load, group fuses and abnormal heating. Qualified personnel should perform mains-voltage tests using suitable test equipment.

Review the nameplate photograph, test results and whether the front connector is included. Confirm availability, price and any warranty terms for the actual unit offered.

Related topics and product groups

S7-300 overview  |  S7-300 CPU modules  |  Digital input modules

Digital output modules  |  Used Siemens products  |  Analog module range

Function modules  |  Used equipment overview  |  OtomasyonAVM home

Manufacturer references

Siemens – 6ES7322-1FH00-0AA0 product information  |  Siemens – technical data sheet (archived copy)  |  Siemens – S7-300 module manual, section 3.22 (archived copy)