6ES7322-1BF01-0AA0

Siemens 6ES7322-1BF01-0AA0 – SM322 8-Output 24 V DC / 2 A Module

6ES7322-1BF01-0AA0 is a Siemens SIMATIC S7-300 SM322 module with 8 digital outputs, rated at 24 V DC and 2 A per channel. When choosing among S7-300 digital output modules, assess the group current limit, load type and wiring arrangement alongside the individual channel rating.

Controlling DC loads

The module operates suitable solenoid valves, DC contactors and signal lamps. Its permitted L+ supply range is 20.4–28.8 V DC. Size the 24 V DC power supply for continuous consumption, simultaneous loads and starting currents.

Check each load's voltage, operating current and any coil suppression device. Investigate field wiring and load faults before fitting a replacement module. Leaving a damaged cable or faulty coil connected can cause the same problem to return after replacement.

Channel rating and group current limit

The outputs form two isolated groups of four channels. The maximum total current is 4 A per group, for horizontal mounting up to 60 °C and vertical mounting up to 40 °C. Operating all four channels in one group at 2 A simultaneously would require 8 A and exceed that limit.

Calculate the load allocation separately for each group. For example, two 2 A loads already use the entire group allowance. Include combinations that may occur during maintenance or manual operation, as well as the normal automatic sequence.

20-pin front connector and project checks

Field wiring uses one 20-pin front connector. Confirm whether the connector is included with the supplied unit. Compare terminal tightness, contact condition, wire labels and group supplies against the electrical drawings. Recording the wiring and module label before removal helps prevent confusion during replacement.

Check the installed S7-300 CPU, module slot and output addresses in the PLC project. Match the STEP 7 hardware configuration to the physical arrangement and field labels. Compare complete order numbers before treating another SM322 version as an equivalent replacement.

Protection and status monitoring

The module provides electronic short-circuit protection. Connecting outputs in parallel to increase current is not supported. Each channel has a green status LED, while diagnostic and interrupt functions are unavailable. An illuminated LED alone does not prove that the connected load is operating.

Where actual operating status is needed, use suitable feedback through a digital input. Displaying the command and field feedback separately on an HMI can help maintenance staff locate a fault.

Assessing a used module

When assessing this model among used Siemens products, check all eight channels and both supply groups with suitable loads. Look for outputs remaining on, intermittent operation, voltage drop and heating. Evaluate any test result alongside the load current, number of simultaneous channels and test duration.

Confirm the label, connector, availability, price and any warranty terms before ordering. Appearance and illuminated channel LEDs alone are insufficient evidence of correct operation under load.

Related topics and product groups

S7-300 overview  |  S7-300 CPU modules  |  Digital input modules

Digital output modules  |  Function modules  |  Analog module range

Used Siemens products  |  Used equipment overview  |  OtomasyonAVM home

Manufacturer references

Siemens – 6ES7322-1BF01-0AA0 data sheet (archived copy)  |  Siemens – S7-300 module manual, section 3.28 (archived copy)  |  Siemens – SM322 DO 8 × DC 24 V / 2 A online manual