6ES7321-1FF10-0AA0
Siemens 6ES7321-1FF10-0AA0 S7-300 SM 321 AC Digital Input Module
Siemens 6ES7321-1FF10-0AA0 is an SM 321 ISOL module with eight 120/230 V AC digital inputs. It acquires AC field signals in SIMATIC S7-300 systems. Its separate reference connection for each channel and 40-pin front connector are important features when selecting this exact order number.
Individual channel isolation and the common-phase requirement
The eight inputs are electrically isolated in groups of one. Isolation is also provided between the inputs and the backplane bus. However, Siemens requires all load voltages to be connected to the same phase. Individual channel isolation does not permit unrestricted use of different mains phases.
Input voltage and signal detection
The nominal input rating is 120/230 V AC at 47–63 Hz. Specified logic levels are 0–40 V AC for “0” and 79–264 V AC for “1”. Typical current at signal “1” is 7.5 mA at 120 V and 17.3 mA at 230 V. The maximum permissible quiescent current for a two-wire sensor is 2 mA.
Input delay is a maximum of 25 ms in either direction and is not configurable. For applications requiring short-pulse detection, assess this delay together with sensor response time and the scanning behaviour of the S7-300 CPU program. Check the field signal's nominal voltage and off-state leakage current before selecting the module.
Status indication and operating conditions
Each input has a green status LED. The module provides no hardware interrupts, diagnostic interrupts or diagnostic functions. Investigating an input problem therefore requires checking the LED indication, actual terminal signal and input state read by the PLC together.
Siemens permits all eight inputs to operate simultaneously at temperatures up to 60 °C with horizontal mounting or 40 °C with vertical mounting. Check the cabinet temperature and mounting orientation in the existing installation.
40-pin connection and system compatibility
Field wiring uses one 40-pin front connector. Confirm separately whether it is included with the offered unit. Match channel references, terminal assignments and phase arrangement to the manufacturer's diagram for 6ES7321-1FF10-0AA0.
Record the module nameplate and existing connections before replacement. Check the module position, input start address and programmed signal assignments in the Siemens S7 PLC project. For ET 200M installations, also assess interface-module and hardware-configuration compatibility.
Evaluating a used module
For a used Siemens unit, inspect the complete order number, hardware version, front-connector socket and rear connections. Include heat damage, corrosion and broken connection components in the assessment. In a suitable protected AC test setup, check all eight inputs individually and compare the applied signal with the LED and PLC input state.
The test record should identify the voltage used and channels checked. Provide the complete product code, required quantity and a clear nameplate photograph when requesting a quotation, and confirm the connector and accessory scope separately.
PDF files and manufacturer references
Visit the S7-300 PDF files section for wiring information and technical limits. Section 3.18: DI 8 × AC 120/230 V ISOL of Siemens' module data manual covers this order number.
Manufacturer references: Siemens product record | Technical data sheet | S7-300 module data manual
Related topics and product groups
Siemens S7-300 | S7-300 CPU modules | S7-300 digital output modules | S7-300 PDF files
Siemens S7 PLC | Used Siemens | Used automation equipment | OtomasyonAVM