6ES7321-1CH80-0AA0

Siemens 6ES7321-1CH80-0AA0 – S7-300 SM 321, 16 Inputs, 48–125 V DC

6ES7321-1CH80-0AA0 is an SM 321 module with 16 digital inputs rated at 48–125 V DC in the Siemens SIMATIC S7-300 family. It is the SIMATIC Outdoor version for extended environmental conditions and uses a 20-pin front connector.

Inputs and isolation: The inputs form two groups of eight. Electrical isolation is provided between groups and between the inputs and backplane bus. When replacing a digital input module, compare the 1M/2M group commons and existing wiring with the manufacturer’s diagram.

Sensor compatibility: Contacts and two-, three- or four-wire proximity sensors with suitable voltage ratings can be used. The inputs have IEC Type 1 characteristics. Two-wire sensors must have an off-state current of 1 mA maximum. Check sensor supply and output ratings against the PLC input circuit.

Temperature and simultaneous input limit: Outdoor operating limits are −25 to +60 °C horizontally and −25 to +40 °C vertically. The permitted number of simultaneously active inputs also depends on voltage and temperature. For example, at 125 V DC input voltage and +60 °C with horizontal installation, only 6 inputs per group, 12 in total, may be active simultaneously. At this voltage, eight inputs per group are permitted up to +50 °C.

Input delay: Specified delay is 0.1–3.5 ms for a “0” to “1” transition and 0.7–3.0 ms for a “1” to “0” transition. When reading short pulses, also consider the CPU scan cycle and communication time.

Status indication and diagnostics: Each channel has a green input LED. There are no hardware/diagnostic interrupts or module diagnostic functions. Assess the LED indication together with the input value in the program and field measurements.

Connections and project compatibility: Check the complete order number, hardware revision, STEP 7 hardware definition, slot and input addresses. Confirm whether the front connector and backplane bus connector are included. When comparing other SM 321 modules, review voltage, input grouping and environmental requirements together.

Buying a used module: When buying a used module, inspect the label, terminals, corrosion and repair history. The test report should state the DC voltage applied, channels checked, number of simultaneously active inputs and ambient temperature. A basic room-temperature input test does not replace verification at high temperature and high input voltage.

PDF files and manuals: Use the S7-300 files section for the wiring diagram and voltage/temperature table. Consult the SM 321; DI 16 × 48–125 VDC chapter covering 6ES7321-1CH80-0AA0, together with the SIMATIC Outdoor environmental requirements.

Related topics and categories
S7-300 main page | S7-300 digital input modules | S7-300 digital output modules | S7-300 CPU modules
PLCs and modules | DIN rail power supplies | S7-300 files | Second-hand main page | OtomasyonAVM home

Manufacturer references: Siemens – 6ES7321-1CH80-0AA0 technical data | Siemens – S7-300 module documentation