6ES7 157-0AD82-0XA0
6ES7 157-0AD82-0XA0 – Siemens DP/PA Coupler Ex [ia], 110 mA
6ES7 157-0AD82-0XA0 is the Ex [ia] version of the Siemens DP/PA coupler, connecting PROFIBUS DP to PROFIBUS PA. Its PA interface includes an intrinsically safe supply and integrated barrier. It connects suitable PA field devices to the process control system. See PROFIBUS and PROFINET for an overview of these networks.
PA output and device count
The total current available to PA field devices is 110 mA maximum. The catalog specifies an upper limit of 31 PA devices; the actual number depends on their combined current demand and the voltage drop along the cable. Use each device’s data sheet and the installed cable lengths when calculating the segment.
Transmission rates and configuration
For stand-alone operation, set the DP master to 45.45 kbit/s; the PA side operates at 31.25 kbit/s. This Ex coupler has no separate PROFIBUS address. Configure and assign parameters to the PA field devices in the project.
The coupler can also operate within a DP/PA Link using a compatible interface module. IM 153-2, 6ES7 153-2BA82-0XB0 illustrates this system arrangement. In an S7-300 installation, check the CPU model, master settings and existing Link configuration together.
Supply and diagnostics
The supply is 24 V DC, with a permissible range of 20.4–28.8 V DC. PROFIBUS DP connects through a 9-pin D-sub socket. The front panel has ON, DP and PA LEDs. This version provides LED diagnostics; coupler diagnostics over PROFIBUS DP and PA ring redundancy are not supported.
Selection for hazardous areas
The module has an IP20 protection rating. Assess its installation location separately from the hazardous-area classification of devices connected to the intrinsically safe PA circuit. Siemens specifies a suitable enclosure providing at least IP54 for Zone 2 installation under the applicable nameplate approval. PA devices must meet FISCO and the relevant Ex connection requirements.
Related models and replacement checks
Siemens lists this model as a compatible replacement for 6ES7 157-0AD81-0XA0. Check the product revision, Ex approvals and existing segment design when replacing it. 6ES7 157-0AC83-0XA0 belongs to the FDC 157-0 DP/PA range; assess its supply and Ex characteristics separately.
6ES7 158-0AD01-0XA0 is a DP/DP coupler that exchanges data between two PROFIBUS-DP networks. See network interface modules for other connection options.
For a used unit, check nameplate legibility, terminal condition, housing damage and repair history. Ask for the PA load used during testing and how communication was verified. Assess Ex suitability using the actual unit’s approvals and documentation.
Editor’s Note: Keep a device list and current calculation for the existing segment when selecting a spare coupler. Store cable lengths, device supply requirements and Ex documentation with the project. This lets you assess the complete field connection when changing a model.
Manuals and PDF documents
Use the Siemens ET 200 manuals section for documentation. Technical details were checked against DP/PA coupler, DP/PA link, Y-link and active field distributors, 12/2021, Sections 4.2 and 12.4, and compatibility against page 280. For Ex requirements, consult Product Information A5E37019095-AF, 07/2022 and the unit’s nameplate. This document applies from product state 02 and includes a Turkish section.
Related topics
Browse other system components under power supply modules, connection modules, terminal blocks, PLCs and modules and PLC and HMI.
For measurement devices, see temperature sensors and pressure sensors. Verify PA communication support and Ex suitability against the specifications of the selected device.
Navigation
Siemens ET 200 | Siemens SIMATIC S7 | Siemens automation | OtomasyonAVM home