6ES7 151-1AB02-0AB0
Siemens 6ES7 151-1AB02-0AB0 ET 200S IM151-1 FO STANDARD
The Siemens 6ES7 151-1AB02-0AB0 is an IM151-1 FO STANDARD interface module for ET 200S. It connects the station to PROFIBUS DP over fibre optic cable, passing input data to the PLC and returning commands to the output modules. The FO designation identifies the optical connection.
Network connection and station capacity
The interface runs as a DPV0 slave and supports transmission rates of up to 12 Mbit/s. Its address space is 128 bytes for inputs and 128 bytes for outputs, with up to 63 power, electronic or motor starter modules in the station.
Module count and data capacity are separate limits. An extension may fit within the permitted number of modules yet exceed the available I/O address space. When adding hardware, check the data requirements alongside the power groups and the module arrangement in the project.
Working with the optical link
Fibre carries the communication signal as light. Matching the visible connector is only part of selecting a cable: the fibre type, connection hardware and link length also matter. During fault finding, check the condition of the fibre ends and the transmitter-to-receiver connections. A cable that looks properly seated does not, by itself, confirm a healthy optical link.
The module uses a 24 V DC supply, and its PROFIBUS address is set by switches. Recording the address and module sequence before removal gives you a useful reference when commissioning a replacement. Compare the physical station with the project and use the PLC diagnostics to narrow down communication or configuration faults.
Adding eight-channel digital inputs
For the 6ES7131-4BF00-0AA0 8DI DC24V input module, Siemens lists 6ES7151-1AB02-0AB0 as the starting compatible FO STANDARD order number. This is a practical reason to identify the exact interface revision before expanding an older station. See ET 200 digital input modules for other input options.
Replacement with the 1AB05 version
Siemens identifies 6ES7151-1AB05-0AB0 as the replacement for the 1AB02. There is an important wiring detail: the physical arrangement of the L+ and M supply terminals changes. Follow the terminal markings and the replacement module’s wiring diagram when reconnecting the supply.
The newer 1AB05 also has 244 bytes of input and 244 bytes of output address space. Those figures do not apply to the 1AB02. Keep the full order number with the station documentation so that replacement information and original specifications remain clear.
Manuals and PDF documentation
Use the Siemens ET 200 user manuals page for wiring and commissioning documents. In the older system manual, select the section for IM151-1 FO STANDARD, 6ES7151-1AB02-0AB0. The 1AB05 manual is particularly useful when checking the replacement and its revised supply-terminal layout.
Related topics
Explore other modules, connections and network options in the ET 200 family:
I/O modules: digital inputs | digital outputs | analog inputs | special input modules | special output modules.
Station hardware: power supply modules | power distribution modules | terminal blocks | connection modules | additional modules.
Networks: PROFIBUS and PROFINET | other network interfaces.
Technology and safety: counter modules | positioning modules | functional modules | safety modules | PROFIsafe.
Explore ET 200
Simatic ET200 | About Siemens ET200 PLC | Siemens ET200 User Manuals