6ES5 241-3CA12

Siemens 6ES5 241-3CA12 – SIMATIC S5 IP 241 MIR Position Decoder

The Siemens SIMATIC S5 6ES5 241-3CA12 is an IP 241 MIR position decoder used to process machine position measurements in an S5 control system. Match the full 241-3CA12 order number on the label when choosing a spare. Several different modules carry the IP 241 designation.

MIR version and digital IP 241 modules

Siemens' digital IP 241 manual covers the 6ES5 241-1AA12 basic module and its encoder matching modules. The catalogue lists the 6ES5 241-1AA11, incremental 1AB11, Excess-3 Gray 1AC11, absolute binary/BCD 1AD12 and synchronous serial 1AF12 under separate order numbers. Use the machine wiring diagram for the 3CA12 when identifying the MIR module's connections.

For incorrect position readings, check the installed position sensor or encoder label, the S5 cables and connectors and the shield connection together. If the machine uses a rotary encoder, check the encoder coupling for play. Match the measurement principle, output signal and supply voltage when selecting a second-hand encoder.

Evaluating the 3CA13 as a spare

A repair listing identifies the 6ES5 241-3CA13 as the replacement for the 3CA12. Siemens' 3CA13 manual describes five analog position channels and one pressure measurement channel, with FB105 for programming. It also shows an S5-115U example with a CPU 944. Before swapping modules, verify the S5 rack, front connector pinout, STEP 5 address and block calls against the machine documentation.

Identifying similar S5 modules

The IP 240 1AA12 and IP 240 1AA21 handle counting and position measurement. The incremental IP 246, absolute IP 246 and IP 266 are positioning modules. The IP 247 and IP 267 control stepper motors, while the IP 288 handles fast/slow positioning. When troubleshooting, use the STEP 5 project to identify which module supplies the position value. To sell a 3CA12 module, send label and front connector photos to otomasyonavm@gmail.com.

Editor's note

Before removal, photograph the full order number, hardware revision, rack slot and front connector markings.

Back up the STEP 5 project. Record the module address and the blocks that read the position value.

With power isolated, inspect the connector latch, pins and shield connection. Record the existing switch and jumper positions.

If evaluating a 3CA13, compare the front connector pinout and supply terminals with the machine diagram before applying power.

In maintenance mode, with movement secured, compare the PLC readings at two known positions. Check the direction and scaling of the readings.

PDFs and part references

+ Siemens IP 241 K manual (EN) – 6ES5 241-3CA13

+ Siemens digital IP 241 manual (EN) – basic module and encoder matching modules

+ Siemens digital IP 241 manual (DE) – basic module and encoder matching modules

+ 6ES5 241-3CA12 MIR listing – supplier catalogue, p. 10

+ 3CA12 and 3CA13 replacement listing – repair catalogue, p. 6

+ Siemens S5 PDF archive

Related topics

+ S5 interface modules

+ S5 expansion modules and adapter casings

+ About Siemens S5 PLCs

Navigation

+ S5 positioning modules

+ SIMATIC S5 modules

+ Siemens S5 PLCs

+ Second-hand Siemens automation